It can be used to protect the moving edge of the machine tool to install safe touch edges.
It can be used to protect the moving edge of the machine tool to install safe touch edges.
It can be used to protect the moving edge of the machine tool to install safe touch edges.
It can be used to protect the moving edge of the machine tool to install safe touch edges.
It can be used to protect the moving edge of the machine tool to install safe touch edges.
Model
LS-PSE

Item specifics

Maximum sensing angle
<90°
Detection method
Pressure sensing method
Mechanical life
>3,000,000 times

Product review

Description

Product Features

The safety edge is a belt type safety switch, and the safety edge or safety buffer can be classified as a "belt" device. The safety edge completely relies on its sense and switching ability to provide safety protection, so reliable control of the safety edge or the control circuit of the safety buffer is very important. Usually the safety edge or safety buffer is only used on machines where the moving parts can be stopped immediately after the power is removed.

Installation Precautions

1) Do not lift or move the Safety protection edge by pulling the cable.

2) Please use a dedicated bracket to install the Safety edge sensor.

3) Do not fold or punch holes on the Anti-collision safety touch edge.

4) Do not install the Safe edge protection on the raised area, but install it on a smooth and smooth surface.

project

Safe touch

Detection method

Pressure sensing method

Maximum sensing angle

<90°

Trigger force (according to specifications and usage)

≥50N-250N

Mechanical life

>3,000,000 times

Surface protection layer material

TPE elastomer, EPDM rubber, CR rubber

Ambient temperature

-20 degrees -55 degrees

Protection level

IP65

Maximum humidity (23 degrees)

95% (condensation)

Response time

13ms

Security Classification

stand by

stand by

Cat.3

Cat.3

>30 years

>30 years

3*107

3*107

52560/year

52560/year

6.99*10-10 1/h (SIL3)

6.99*10-10 1/h(SIL3)

The safety edge contact system composed of the safety edge and RS8300, SRA/B safety controller complies with the following standards.

EN1760-2 ISO1856-2 EN62061 EN ISO138849-1 IEC61508 EN60204-1

 

Safety contact edge profile table
Safety touch edge mounting base and applicable specifications
Application

Moving table of machine tool:

The safety edge is installed on the moving part of the reciprocating workbench when it is detected that a worker touches it. The Escalator safety edge can stop the workbench from moving, preventing workers from colliding with the moving part or squeezing between the moving part and the wall or column. Escalator safety edge can be classified as a "belt" device. Escalator safety edge does not restrict access but only "feels" it. Escalator safety edge relies on its sense and switching capabilities to provide safety protection, so reliable control of the safety edge or safety buffer control circuit is very important.