The safety edge is used on the edge of the rolling door to control the lifting.
- Model
- LS-PSE
Item specifics
- Maximum sensing angle
- <90°
- Detection method
- Pressure sensing method
- Mechanical life
- >3,000,000 times
Review
Description

Bend edge is a long strip of rubber material that can be bent. It can be fixed on the edge where there is a danger of squeezing and shearing for safety protection. If the controller is connected, the pressure output switch signal is detected, and the personal safety can be protected by controlling the machine circuit.
Apply vertical pressure to the safety edge to make the conductors of the internal induction belt contact each other, this time causing the resistance and current to change, which will be further analyzed by the control unit. If the Escalator safety edge is installed correctly, as long as the internal induction strap is not damaged, it can function normally even if the Escalator safety edge jacket is damaged.

Storage and use environment requirements:
1) Do not store or use the Safety edge sensor in an environment exposed to direct sunlight for a long time.
2) Safety margin should not be stored and used outside the range of -35℃ to +80℃.
3) Do not store or use Safe touch outside the range of 86~106KPa air pressure
4) Do not store and use the Safety edge sensor in an environment containing strong corrosive or flammable gas.
